EasyDriver v4.4 Stepper Motor Driver A3967 Drive (Max 30V)

  • Was  RM20.00 
  • RM11.00

  • Product Code: Easy Driver A3967
  • Availability: In Stock

EasyDriver Stepper Motor Driver A3967 is a complete micro stepping motor driver with built-in translator. It is designed to operate bipolar stepper motors in full-, half-, quarter-, and eighth-step modes, with output drive capability of 30 V and ±730 mA. Includes a fixed off-time current regulator that has the ability to operate in slow, fast, or mixed current-decay modes. This current-decay control scheme results in reduced audible motor noise, increased step accuracy, and reduced power dissipation. In this latest v4.4 had fixed the silk error on the min/max adjustment.

The translator is the key to the easy implementation of the A3967SLB. By simply inputting one pulse on the STEP input the motor will take one step (full, half, quarter, or eighth depending on two logic inputs). There are no phase-sequence tables, high-frequency control lines, or complex interfaces to program.



  • A3967 Microstepping Driver
  • MS1 and MS2 pins broken out to change microstepping resolution to full, half, quarter and eighth steps (defaults to eighth)
  • Compatible with 4, 6, and 8 wire stepper motors of any voltage
  • Adjustable current control from 150mA/phase to ±730mA/phase , 30 V Output Rating
  • Power supply range 6V - 30V. The higher the voltage, the higher the torque at high speeds
  • Automatic Current Decay Mode Detection/Selection
  • 3.0 V to 5.5 V Logic Supply Voltage Range
  • Mixed, Fast, and Slow Current-Decay Modes
  • Internal UVLO and Thermal Shutdown Circuitry
  • Crossover-Current Protection 


Note: Do not connect or disconnect a motor while the driver is energized. This will cause permanent damage to the A3967 IC.





Connect EasyDriver to an Arduino



Write a review

Note: HTML is not translated!
    Bad           Good


Related Products

Tags: Stepper Motor Driver, Stepper Motor