Battery Charger TP4056 w/ Discharge Cut-Off Protection for Single-Cell LiPo / 18650

  • Was  RM10.00 
  • RM4.00

  • Product Code: Battery Charger TP4056 w/ protect
  • Availability: In Stock

 

Ideal for adding an embedded battery charger to your new project.

 

Features

  • Charger for single-cell lithium or lithium multi-section parallel
  • 18650 or Li-Po Battery with 3.6V, 3.7V, etc
  • Discharge & cut-off protection
  • Charging ports input power via USB or solder pads + and –

 

Specifications

  • Input voltage: 5VDC
  • Full charge voltage: 4.2V
  • Charging current: 1Amp
  • Charging indicator light: Red
  • Fully charged indicator light: Green
  • Working temperature: -10 Degree to +85 Degree
  • Charging IC: TP4056
  • Protection IC: DW01

 

Instructions

  • Connect micro USB cable for power, or 5V DC to pads marked IN+ and IN- on left-hand side of the module
  • Connect cell to charge to B+/B- pads on right-hand side of module
  • A load (something for the battery to power) can be connected to the OUT+/OUT- pads on the right-hand side
  • Important! Disconnect load when charging
  • Red LED indicates while charging in progress
  • Green LED indicates when fully charged
  • Never charge your battery at a rate greater than 1C

 

Note: All battery should not having their own protection circuit board while connect with this charger board.

Once the battery voltage drop below 2.4V will automaticly cut-off to protect against over-voltage and reverse polarity connection.

 

* Output is optional

 

Write a review

Note: HTML is not translated!
    Bad           Good

 

Related Products

Tags: 18650