AC to DC Adapter 12V 1A Switching Power Supply

  • Was  RM12.50 
  • RM10.00

  • Product Code: adapter-12v-1a
  • Availability: In Stock

This power supply takes any input from 100V up to 220V AC, which is what comes out of your wall socket, and output 12V DC.

 

Applications

  • Arduino UNO / MEGA, DC motors, LCD screens, DVD players, Hard Drives, Audio Gear, and most other digital devices use less than 1 Amperage .

 

Specifications

  • Input : 110~240V AC  50/60HZ
  • Output : DC 12V
  • Output Current: 1A
  • Standby power: Less than 0.1W
  • Operating Temperature: 0°C to +55°C
  • Cable length: 70 cm
  • DC Plug Dimension: 5.5mm x 2.1mm
  • DC Plug polarity: Positive (+) Inside, Negative (-) Outside.

 

Package Content

1 x Adapter

 

 

FAQ – How to choose

In order to find the correct power supply for your device, you will need two pieces of information. These are Voltage (measured in Volts or V) and Amperage (measured in Amps or A). You can find this information off the back of the old power supply, or off the back of the device itself. If you do not find it on the device, you can check the manufacturer's website, or in the device's manual under "specifications".

Voltage:
All of the power supplies we sell are various from 5V to 24V DC. They take any input from 100V up to 220V AC, which is what comes out of your wall socket, and output 12V DC. So if your unit is not 12 Volt, you will need to find the correct adapter in our website.

Amperage:
Once you have confirmed that you need a 12 Volt power supply, you will need to find out how much power your device draws. This is called amperage. Next to the 12V in the specifications there will be another number followed by a capital "A" for Amps. You will need a power supply that can supply enough power for your device. If your device says it draws 3 Amp (3A), you need to use a power supply that can put out at least that many Amps. If your device states it needs 3A, then you can use a 3A, or 4A, or 5A unit. All will work.

If the Amperage of your device is uneven, such as 3.13A or 4.16A, always round up. 3.13A rounds up to a 3.5A adapter, a 4.16A device will round up to a 4.5A or a 5A.

Connector:
All our power supplies have a connector that is standard for a 12V DC device. Most 12V DC devices use the standard tip. This tip is 5.5mm (outer barrel) by 2.5mm (inner barrel) and is center positive. It is a simple round barrel connector. To repeat, if you match the voltage and amperage, then you should not have to worry about the connector type accept in the rare occasion when your device has an unusual connector such as a double barrel, or a 4-pin, but these are easy to spot as the jack where the adapter plugs in will not be a simple circular barrel with a pin inside.

 

Suggestions

DC Jack (Female) 2.1mm Connector w/ Screw Terminal Block

  • Easy to install
  • ABS material housing

Write a review

Note: HTML is not translated!
    Bad           Good

 

Tags: AC to DC Adapter