Joystick Module XY & Z-axis

  • Was  RM14.00 
  • RM6.50

  • Product Code: Joystick Module XY
  • Availability: In Stock

PS2 game joystick axis sensor module consists of using original quality metal PS2 joystick potentiometer system For the (X, Y) a 2-axis analog output and for (Z) 1 digital output channel button.

 

Features

  • Good quality joystick, long life, stable performance
  • Two analog outputs, digital outputs
  • X, Y-axis output of two potentiometers can be read through the AD converter twist angle
  • Press down on the joystick, touch switches can be deployed all the way, as a digital output, has a pull-up
  • Applies to two degrees of freedom, or other remote PTZ control servo proportional control
  • Suitable for Arduino platform compatible

 

Package Content

  • 1 x Joystick Module

 

Connect to Arduino

/*
  Example sketch for the Addicore 2-Axis Joystick with push switch
  Wire the Addicore joystick to your Arduino as detailed below. Then
  Upload this code to your Arduino and open the Serial Monitor on your
  computer to see the states of the joystick axes and push switch.
  (Make sure the baud is set to 9600 in your Serial Monitor)
  
  Wiring:
              Joystick ---> Arduino
                 GND          GND
                 +5V          5V
                 VRx          A0
                 VRy          A1
                 SW           3
                 
  Created: by Craig Thompson, December 15, 2014
*/

//Arduino pins attached to joystick 
#define joystick_switch_pin  3
#define joystick_x_pin       A0
#define joystick_y_pin       A1

// the setup routine runs once when you press reset:
void setup() {
  Serial.begin(9600);                          // initialize serial communication at 9600 bits per second:
  pinMode(joystick_switch_pin, INPUT_PULLUP);  // Enable the pullup resistor on pin 3 for the joystick's switch signal
}

// the loop routine runs over and over again forever:
void loop() {
  int X_Axis = analogRead(joystick_x_pin);     // read the x axis value
  int Y_Axis = analogRead(joystick_y_pin);     // read the x axis value
  Y_Axis = map(Y_Axis, 0, 1023, 1023, 0);      // invert the input from the y axis so that pressing the stick forward gives larger values
  int SwitchValue = digitalRead(joystick_switch_pin);  // read the state of the switch
  SwitchValue = map(SwitchValue, 0, 1, 1, 0);  // invert the input from the switch to be high when pressed
  
  // print out the values you read:
  Serial.print("Switch: ");
  Serial.print(SwitchValue);
  Serial.print("   X_Axis: ");
  Serial.print(X_Axis);
  Serial.print("   Y_Axis: ");
  Serial.println(Y_Axis);
  delay(10);        // delay in between reads
}

 

Write a review

Note: HTML is not translated!
    Bad           Good