• Temperature Sensor Waterproof Probe DS18B20

Temperature Sensor Waterproof Probe DS18B20

  • Was  RM15.00 
  • RM10.00

  • Product Code: Temperature Probe DS18B20
  • Availability: In Stock

DS18B20 temperature sensor probe chip with high-quality stainless steel anti-rust waterproof probe housing. Ideal for getting soil temperature, Arduino and other development systems.

Features:

  • Stainless steel casing (6 * 30mm), length 100cm lead
  • 3.0V ~ 5.5V DC power supply
  • Temperature range -55°C ~ +125°C
  • No external components, unique single bus interface
  • Output leads: Will be 1 of the below configurations.

 

Connect Probe with your Arduino Tutorial (garagelab)

Connection: The sensor has 3 wires: red (VCC), black (GND) and white/yellow (DATA).
Connect the red to +5V, the black to GND and the white to the digital pin D10. Then, put a 4.7kohm resistor between the white wire and the +5V.

Now, download and install this library. Then upload the following code:

#include <OneWire.h> 
int DS18S20_Pin = 10; //DS18S20 Signal pin on digital 2

//Temperature chip i/o
OneWire ds(DS18S20_Pin); // on digital pin 2

void setup(void) {
  Serial.begin(9600);
}

void loop(void) {
  float temperature = getTemp(); //will take about 750ms to run
  Serial.println(temperature);
}


float getTemp(){
    //returns the temperature from one DS18S20 in DEG Celsius
    
    byte data[12];
    byte addr[8];
    
    if ( !ds.search(addr)) {
      //no more sensors on chain, reset search
      ds.reset_search();
      return -1000;
    }
    
    if ( OneWire::crc8( addr, 7) != addr[7]) {
      Serial.println("CRC is not valid!");
      return -2000;
    }
    
    if ( addr[0] != 0x10 && addr[0] != 0x28) {
      Serial.print("Device is not recognized");
      return -3000;
    }
    
    ds.reset();
    ds.select(addr);
    ds.write(0x44,1); // start conversion, with parasite power on at the end
    
    delay(750); // Wait for temperature conversion to complete
    
    byte present = ds.reset();
    ds.select(addr); 
    ds.write(0xBE); // Read Scratchpad
    
    
    for (int i = 0; i < 9; i++) { // we need 9 bytes
      data[i] = ds.read();
    }
    
    ds.reset_search();
    byte MSB = data[1];
    byte LSB = data[0];
    float tempRead = ((MSB << 8) | LSB); //using two's compliment
    float TemperatureSum = tempRead / 16;
    return TemperatureSum;
}

The above code acquires the temperature in Celsius and display it over the serial connection. The Arduino checks if the sensor is connected. Then it sends the sensor address and reads the data.

Open the serial monitor and start reading the temperature!

Also, you can convert Celsius to Fahrenheit. Have fun!

 

References:

http://bildr.org/2011/07/ds18b20-arduino/

http://www.arduino.cc/playground/Learning/OneWire

https://rik94566.wordpress.com/tag/miles-burton/

 

Datasheet:

http://dlnmh9ip6v2uc.cloudfront.net/datasheets/Sensors/Temp/DS18B20.pdf

Write a review

Note: HTML is not translated!
    Bad           Good

 

Related Products