PICkit 2 - PIC Development Programmer / Debugger (Clone)

  • RM79.50

  • Ex Tax: RM75.00
  • Product Code: PICkit2
  • Availability: In Stock

PICkit 2 Debug Express allows in-circuit debugging on selected PICmicro microcontroller units (MCUs). In-circuit debugging allows the designer to run, examine, and modify the program while the PICmicro MCU is embedded in the hardware, thereby assisting the designer in debugging the firmware and hardware together. Debug Express interacts with MPLAB IDE software. Programs can be run, stopped, and single-stepped. One breakpoint can be set and the processor can be reset. The PICkit 2 Starter Kit is a low-cost development kit with an easy to use interface for programming many of Microchip’s baseline, midrange and PIC18F families of Flash memory microcontrollers. This starter kit is designed to help the user get up to speed quickly using PIC microcontrollers.
 
Features
  • USB (Full speed 12 Mbits /s interface to host PC)
  • Real-time execution
  • MPLAB IDE compatible (free copy included)
  • Built-in over-voltage/short circuit monitor
  • Supports low voltage to 2.0 volts (2.0V to 6.0V range)
  • Diagnostic LEDs (power, busy, error)
  • Read/write program and data memory of microcontroller
  • Erase of program memory space with verification
  • Freeze-peripherals at breakpoint
  • Program up to 512K byte flash with the Programmer-to-Go
 
Debugging & Programming 
  • PIC12F683* 
  • PIC16F684*, 685*, 687*, 688*, 689*, 690* 
  • PIC16F883, 884, 886, 887 
  • PIC16F913, 914, 916, 917, 946

 

  • These devices require an ICD header board to enable debugging with them Programming only
  • PIC12F508, 509, 510 
  • PIC12F675 
  • PIC16F505, 506

Package included:

1 x Pickit2
1 x Programming cable
1 x 6pin Pin Header
1 x USB cable

 

Recommendations

Universal Programmer Seat for PIC 1CD2 KIT2 KIT3 Adapte

Write a review

Note: HTML is not translated!
    Bad           Good

Similar Products