Power Line Carrier Module KQ-130F - Data Transceiver via Power Line

Power Line Modem KQ-130F, communications systems operate by adding a modulated carrier signal to the wiring system

Specifications

• Working rate:120 ~ 135KHZ
• Interface baud rate: 9600bps, the true baud rate is 100bps,250-byte buffer
• Temperature: -25 degree~+70 degree
• Humidity: ≤90%
• Power: DC +5V
• Receiver: ≤11mA Transmitter:≤300mA

Pinouts

1. AC: 220V AC voltage Live (or Neutral)
2. AC: 220V AC voltage Neutral (or Live)
3. +5 V to send power (210mA), for receiving data can be un-connected to reduce power consumption
4. GND: Digital circuit ground
5. +5 V operating supply 11mA, the lowest operating voltage is 3.3V (but not recommended)
6. RX: TTL level, carrier data into, then MCU TXD
7. TX: TTL level, carrier data out, then the microcontroller RXD
8. MODE: mode selection, un-connected or connected to 5V high
9. NC/RST: reset pin (active low) frequent switching mode. Do not need this feature, the pin should be left unconnected

Package Includes

1x Power Line Modem KQ-130F