RS485 to UART Serial Two-way Converter Module

Only one in the whole network, 3.3V and 5.0V power supply, RS485 signal perfectly compatible with automatic flow control module.
Without "Receiving - launch" control, this module is as simple to use with your serial port operations.

Highlights

• Compatible with 3.3V and 5.0V power supply
• Compatible with 3.3V and 5.0V signal
• Absolute using imported chips, industrial design, anti-interference ability, while using more effective mine design can be used in the industrial field and harsh field environments, the working temperature of -40 ℃ to + 85 ℃ transmission distance up to 1 kilometer (made with 850 meters of cable F1.5 tests recommended in the 800 meters, more than 800 m, please add repeaters)
• Semi-hole pads, onboard module, thin PCB, having a thickness of 0.8mm
• RXD, TXD signal indicator light, monitor send and receive status

Features

• The module is fully considered mine design, long-distance transmission signal 485 in the wild, the module "Connected to the ground" terminal is connected to the earth, can play a very good anti-jamming and anti-lightning effect, more secure; it can not connect with the ground when the indoor short-distance transmission
• Using the standard 2.54 pitch design, easy secondary development
• Has a 120 ohm termination resistors, shorted R0to enable the termination resistor
• Support multi-machine communication, allowing access at up to 128 devices on the bus
• Hot swap, the signal does not appear dead phenomenon
• Large area of copper to prevent interference
• Size: 43mm x 15.3mm x 3mm

Related Discussion

YosemitechModbus