Power Line Carrier Module KQ-130F - Data Transceiver via Power Line

  • RM95.00

  • Product Code: KQ-130F
  • Availability: In Stock

Power Line Modem KQ-130F, communications systems operate by adding a modulated carrier signal to the wiring system



  • Working rate:120 ~ 135KHZ
  • Interface baud rate: 9600bps, the true baud rate is 100bps,250-byte buffer
  • Temperature: -25 degree~+70 degree
  • Humidity: ≤90%
  • Power: DC +5V
  • Receiver: ≤11mA Transmitter:≤300mA



  1. AC: 220V AC voltage Live (or Neutral)
  2. AC: 220V AC voltage Neutral (or Live)
  3. +5 V to send power (210mA), for receiving data can be un-connected to reduce power consumption
  4. GND: Digital circuit ground
  5. +5 V operating supply 11mA, the lowest operating voltage is 3.3V (but not recommended)
  6. RX: TTL level, carrier data into, then MCU TXD
  7. TX: TTL level, carrier data out, then the microcontroller RXD
  8. MODE: mode selection, un-connected or connected to 5V high
  9. NC/RST: reset pin (active low) frequent switching mode. Do not need this feature, the pin should be left unconnected


Package Includes

1x Power Line Modem KQ-130F


Write a review

Note: HTML is not translated!
    Bad           Good