Tower Pro SG-5010 Standard Servo Motor, max 6.5KG per cm, 180 / 360 Degree

Tower Pro SG5010 standard servo can rotate approximately 180 degrees (90 in each direction) or 360 degrees. You can use any servo code, hardware or library to control these servos. Good for beginners who want to make stuff move without building a motor controller with feedback & gear box. Comes with 3 horns, as shown. They aren't the highest quality servo (which is why they are less expensive) and so are not suggested for hobby planes.

To control with an Arduino, we suggest connecting the orange control wire to pin 9 or 10 and using the Servo library included with the Arduino IDE. Position "0" (1.5ms pulse) is middle, "90" (~2ms pulse) is all the way to the right, "-90" (~1ms pulse) is all the way to the left.

• Stall torque 5.5kg/cm(4.8V);   6.5kg/cm(6V);
• Operating speed 0.2sec/60degree(4.8v);   0.16sec/60degree(6v)
• Operating voltage 4.8-6V
• Temperature range 0℃_ 55℃
• Dead band width 10us
• Weight 38g
• Dimension 40.2*20.2*43.2mm

The wire colors are:

• Red = Battery(+) 
• Brown = Battery(-) 
• Orange = Signal